Drive train, motor, control systems ( help in writing some pages on Coursework

Drive train, motor, control systems ( help in writing some pages on these parts and relate them to my simple design ) - Coursework ExampleFor this electric skateboard, it is expected that the front pad pull up stakes be used for acceleration while the rear pad shall be used in the braking system. twain pads impart be connected at the center that shall comprise of an electric circuit board to be used in powering the system, as shown in the figure below.Normally, the controller will control the voltage flood tide from the batteries to the motors, except for when batteries are dead. Therefore, the regenerative power shall be used in cont whorl the voltage flow which will allow for the recharging of the batteries in a vice versa way without needing to plug the batteries to an external power source. The regenerative technique to be employed in this design shall work through a rotational basis of its mechanical efficacy hence, re-populating the batteries.During the rotational process of the motor wheels, there is mechanical energy that is released. Through the regenerative technique, this energy shall be channeled patronize into the battery system and into the motor through the axles. Therefore, as the mechanical energy goes through the axle and motor again, it causes a rotational movement inside of the motor thus, form an electrical field of battle in the motor. The created electric field will then push back the mechanical energy to the batteries through the controller. In this stage, since the controller was responsible for(p) for gauging the electric flow out of the batteries, it would also regulate the inflow of the mechanical energy caused by the rolling of the wheels during skating, into the battery system, by raising the level to feed the batteries again.Taking on the form of a pelvic inflammatory disease system, the controller can further take on the form of a remote sensor convenience clutched in the hands of the user to apply the start of the board , acceleration and deceleration speeds of the board. The standard recharging time for the batteries